3-D Printed Drill Press Pulley


Had to replace the motor on our drill press. The replacement runs faster than the original, soooo, 3D Print a new one! The top photo is the original pulley with the bearings and tensioner removed. The next two are Sketch …

Posted in 3D printing, building, hangedman enterprises | Leave a comment

Horse paddock in place


Horse paddock is set up. Here’s my plan in Sketch Up and the end result. Run in shelter goes in in June. Horses next weekend.

Posted in Equestrian, general info, landscape, Uncategorized | 1 Comment

Good Water! and 2 3d print sales


Culligan came by and installed our water filter-softener. Also sold him 2 custom rubber key fobs styled on his Jeep grille. His (shown) is for a 1952 GPW, and the one for his brother is a 1952 CJ3A.

Posted in 3D printing, building, general info, hangedman enterprises, Uncategorized | Leave a comment

Spring has Sprung

Started clearing out an area for a small horse corral. Lots of small stumps to rip out. Chad has been working on the upstairs bathroom of the shop.

Posted in hangedman enterprises, landscape, Uncategorized | Leave a comment

Work at property

Spent Sunday working at the property in Marion. Tractor wouldn’t start. Have to work on that Friday. Chad andĀ  I used the skid steer to sort out some more big rocks from the power line trench. Picked up some odds …

Posted in landscape | Leave a comment

My new bed


Sorted my 2×6 boards into a stack of 7 for the base (left stack) and good looking ones to the right for the headboard, footboard, and supports. The boards were left-overs from a failed motel job, and were harvested and …

Posted in bed | Tagged , , , , | 1 Comment



Kalua, our pitbull, checking out my job of mulchingĀ  all the fall leaves today. (click on her to see the next photo)

Posted in landscape | Tagged , | Leave a comment