Grooming and a walk

http://tikimt.com/wp-content/uploads/2016/03/2016-03-19-2-300x225.jpg

Jill and I groomed our horses and then took them for about a half mile walk in the woods.

Posted in Equestrian | Leave a comment

Pedicure time

http://tikimt.com/wp-content/uploads/2016/03/2016-03-15-4-300x225.jpg

Burlesque and Willy getting their hooves done by our farrier, Tawnya.

Posted in Equestrian, Uncategorized | Leave a comment

Contented horsies

http://tikimt.com/wp-content/uploads/2016/03/2016-03-13-300x225.jpg

A nice snack after some grooming and just under a mile walk. Behaved well when 2 quads went by, followed by a truck. Then the quads came back with a dirt bike along.

Posted in Equestrian | Leave a comment

Our Horsies are Home!

http://tikimt.com/wp-content/uploads/2016/03/IMG_20160312_152043_239-225x300.jpg

Willy and Burlesque made the move from where they were being boarded to their new home in Marion with only one scraped shin.

Posted in Equestrian | 1 Comment

3-D Printed Drill Press Pulley

http://tikimt.com/wp-content/uploads/2016/03/pulley-remake-146x300.png

Had to replace the motor on our drill press. The replacement runs faster than the original, soooo, 3D Print a new one! The top photo is the original pulley with the bearings and tensioner removed. The next two are Sketch …

Posted in 3D printing, building, hangedman enterprises | Leave a comment

Horse paddock in place

http://tikimt.com/wp-content/uploads/2016/03/IMG_20160306_152558_673-300x225.jpg

Horse paddock is set up. Here’s my plan in Sketch Up and the end result. Run in shelter goes in in June. Horses next weekend.

Posted in Equestrian, general info, landscape, Uncategorized | 1 Comment

Good Water! and 2 3d print sales

http://tikimt.com/wp-content/uploads/2016/03/ke-fob-300x168.png

Culligan came by and installed our water filter-softener. Also sold him 2 custom rubber key fobs styled on his Jeep grille. His (shown) is for a 1952 GPW, and the one for his brother is a 1952 CJ3A.

Posted in 3D printing, building, general info, hangedman enterprises, Uncategorized | Leave a comment

Spring has Sprung

Started clearing out an area for a small horse corral. Lots of small stumps to rip out. Chad has been working on the upstairs bathroom of the shop.

Posted in hangedman enterprises, landscape, Uncategorized | Leave a comment

Plumbing almost done!

Doing a job like this payday to payday is a pain.

Posted in Uncategorized | Leave a comment

Lots in October

In October we… Poured a 36’x36′ concrete slab. Got grid power hooked up. Had our pump installed in the well. Dug most of the septic system. Had the septic tank delivered along with all the pipe, pump, etc for it. …

Posted in general info | Leave a comment