Grooming and a walk

dennispreston March 20, 2016
[0] comments
http://tikimt.com/wp-content/uploads/2016/03/2016-03-19-2-300x225.jpg

Jill and I groomed our horses and then took them for about a half mile walk in the woods.

There are no comments, click here be the first one!

Pedicure time

dennispreston March 16, 2016
[0] comments
http://tikimt.com/wp-content/uploads/2016/03/2016-03-15-4-300x225.jpg

Burlesque and Willy getting their hooves done by our farrier, Tawnya.

There are no comments, click here be the first one!

Contented horsies

dennispreston March 13, 2016
[0] comments
http://tikimt.com/wp-content/uploads/2016/03/2016-03-13-300x225.jpg

A nice snack after some grooming and just under a mile walk. Behaved well when 2 quads went by, followed by a truck. Then the quads came back with a dirt bike along.

There are no comments, click here be the first one!

Our Horsies are Home!

dennispreston March 12, 2016
[1] comment
http://tikimt.com/wp-content/uploads/2016/03/IMG_20160312_152043_239-225x300.jpg

Willy and Burlesque made the move from where they were being boarded to their new home in Marion with only one scraped shin.

dennispreston says:
Sorry about the captions showing in the tag line. Thank you Wordpress. more
read all

3-D Printed Drill Press Pulley

dennispreston March 8, 2016
[0] comments
http://tikimt.com/wp-content/uploads/2016/03/pulley-remake-146x300.png

Had to replace the motor on our drill press. The replacement runs faster than the original, soooo, 3D Print a new one! The top photo is the original pulley with the bearings and tensioner removed. The next two are Sketch …

read more
 

Horse paddock in place

dennispreston March 6, 2016
[1] comment
http://tikimt.com/wp-content/uploads/2016/03/IMG_20160306_152558_673-300x225.jpg

Horse paddock is set up. Here’s my plan in Sketch Up and the end result. Run in shelter goes in in June. Horses next weekend.

 

Good Water! and 2 3d print sales

dennispreston March 3, 2016
[0] comments
http://tikimt.com/wp-content/uploads/2016/03/ke-fob-300x168.png

Culligan came by and installed our water filter-softener. Also sold him 2 custom rubber key fobs styled on his Jeep grille. His (shown) is for a 1952 GPW, and the one for his brother is a 1952 CJ3A.

 

Spring has Sprung

dennispreston February 29, 2016
[0] comments

Started clearing out an area for a small horse corral. Lots of small stumps to rip out. Chad has been working on the upstairs bathroom of the shop.

 

Plumbing almost done!

dennispreston February 27, 2016
[0] comments

Doing a job like this payday to payday is a pain.

 

Lots in October

dennispreston November 3, 2015
[0] comments

In October we… Poured a 36’x36′ concrete slab. Got grid power hooked up. Had our pump installed in the well. Dug most of the septic system. Had the septic tank delivered along with all the pipe, pump, etc for it. …

read more